Honda SH300 2006 Manual page 279

LEFT CRANKCASE
Remove the driveshaft bearing if it remains in the
Be careful not to
crankcase.
damage the final
Remove the countershaft and final gear shaft bear-
reduction case
ings using the special tools.
mating surface.
TOOLS:
Countershaft bearing:
Bearing remover head, 14 mm 07WMC-KFG0100
Bearing remover shaft
Remover weight
Final gear shaft bearing:
Bearing remover, 20 mm
Bearing remover handle
Remover weight
Apply engine oil to the bearing cavity.
Drive new bearings into the left crankcase with the
marked side facing the attachment until it is fully
seated, using the special tools.
TOOLS:
Countershaft bearing:
Driver
Attachment, 22 x 24 mm
Pilot, 14 mm
Final gear shaft bearing:
Driver
Attachment, 42 x 47 mm
Pilot, 20 mm
Driveshaft bearing:
Driver
Attachment, 48.2 x 51.5 mm
Pilot, 25 mm
FINAL REDUCTION CASE
Remove the side collar, final gear shaft dust seal
and oil seal from the final reduction case.
FINAL GEAR
SHAFT BEARING
WEIGHT
07936-KC10100
07741-0010201
07936-3710600
07936-3710100
07741-0010201
DRIVER
07749-0010000
07746-0010800
07746-0041200
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07946-3290000
07746-0040600
SIDE COLLAR
DUST SEAL
FINAL REDUCTION
COUNTERSHAFT
BEARING
BEARING REMOVER
FINAL GEAR ATTACHMENT
SHAFT BEARING /PILOT
COUNTERSHAFT DRIVESHAFT
BEARING BEARING
OIL SEAL
12-9