Honda SH300 2006 Manual page 295

ALTERNATOR/STARTER CLUTCH
Apply engine oil to the starter reduction gear and
shaft.
REDUCTION GEAR
Set the starter reduction gear properly and insert
the shaft.
SHAFT
Clean any oil from the tapered portions of the crank-
shaft and flywheel. Align
Install the flywheel onto the crankshaft, aligning the
groove with the woodruff key.
FLYWHEEL
Apply engine oil to the flywheel bolt threads and
FLYWHEEL BOLT/WASHER
seating surface.
Install the washer and nut.
Hold the flywheel with the special tool and tighten
the bolt to the specified torque.
TOOL:
Flywheel holder 07725-0040001
TORQUE: 103 N·m (10.5 kgf·m, 76 lbf·ft)
FLYWHEEL HOLDER
Clean the starter driven gear guide bolt threads.
Apply locking agent to the starter driven gear guide
BOLT
bolt threads (page 1-16).
Install the starter driven gear guide and tighten the
bolt.
Install the right crankcase cover (page 13-5).
GEAR GUIDE
13-13