Honda SH300 2006 Manual page 340

FRONT WHEEL/SUSPENSION/STEERING
Install the left handlebar weight and tighten the new
screw.
Set the rear master cylinder by aligning the end of
the master cylinder with the punch mark on the han-
dlebar.
Set the holder with the "UP" mark facing up and
tighten the upper bolt first, then tighten the lower
bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the rear brake light switch and inhibitor
switch connectors.
Set the turn signal relay to the handlebar.
Secure the combination meter/handlebar switch
wire to the wire band.
Install the following:
– rear handlebar cover (page 3-14)
– front handlebar cover (page 3-14)
– front upper cover (page 3-9)
15-26
SCREW
HANDLEBAR WEIGHT
REAR MASTER CYLINDER
HOLDER
BOLTS
"UP" MARK
REAR BRAKE LIGHT
SWITCH CONNECTORS
INHIBITOR SWITCH
CONNECTORS
TURN SIGNAL RELAY
PUNCH MARK
WIRE BAND