Honda SH300 2006 Manual page 281

FINAL REDUCTION ASSEMBLY
Clean the mating surfaces of the final reduction case
and left crankcase.
Install the driveshaft into the bearing.
Position the assembly collar against the driveshaft
bearing inner race and pull the driveshaft into the
bearing until it is fully seated.
TOOLS:
Assembly shaft
Assembly collar
Apply engine oil to the lips and outer surface of a
new driveshaft oil seal.
Install the oil seal until it is flush with the crankcase
using the same tools.
TOOLS:
Assembly shaft
Assembly collar
Apply engine oil to the counter gear teeth and shaft
sliding surfaces.
Apply engine oil to the final gear teeth and shaft
journal.
Assemble the final gear and counter gear, and
install
countershaft and counter gear into the left crank-
case.
07965-VM00200
07YMF-KPB0100
07965-VM00200
07YMF-KPB0100
the final gear shaft, thrust washers,
FINAL REDUCTION
ASSEMBLY COLLAR
ASSEMBLY SHAFT
DRIVESHAFT OIL SEAL
FINAL GEAR COUNTERSHAFT
SHAFT
COUNTER
GEAR
WASHERS
12-11