Honda SH300 2006 Manual page 268

DRIVE AND DRIVEN PULLEYS/CLUTCH
Install the clutch side plate and secure it with the E-
clips
CLUTCH/DRIVEN PULLEY
Assemble the following:
– driven pulley assembly
– spring collar A
– driven face spring
– spring collar B
– spring seat
– clutch assembly
Set the clutch spring compressor over the clutch/
driven pulley assembly by aligning the bosses with
the holes in the clutch.
TOOL:
Clutch spring compressor
Compress the driven face spring while aligning the
To prevent loss of
flat surfaces of the driven pulley and clutch.
tension, do not
Install the clutch/driven pulley nut.
compress the
clutch spring more
than necessary to
install the clutch/
driven pulley nut.
Hold the spring compressor in a vice and tighten the
clutch/driven pulley nut using the special tool to the
specified torque.
TOOL:
Socket wrench, 39 x 41 mm 07GMA-KS40100
TORQUE: 79 N·m (8.1 kgf·m, 58 lbf·ft)
Remove the clutch/driven pulley assembly from the
spring compressor.
11-18
CLUTCH SIDE PLATE
DRIVEN PULLEY
ASSEMBLY
07LME-GZ40201
E-CLIPS
COLLAR A
SPRING
SPRING SEAT
SPRING COMPRESSOR
SPRING COMPRESSOR
NUT SOCKET WRENCH
COLLAR B
CLUTCH
ASSEMBLY
NUT