Honda SH300 2006 Manual page 156

FUEL SYSTEM (PGM-FI)
2. Clean around the pipe and set the rubber cor-
rectly.
Align the quick connect fitting with the pipe and
Do not bend or
align the retainer locking pawls with the connec-
twist fuel hose.
tor grooves.
Then press the quick connect fitting onto the
pipe until both retainer pawls lock with a
"CLICK".
If it is hard to connect, put a small amount of
engine oil on the pipe end.
3. Make sure the connection is secure and that the
pawls are firmly locked into place; check visually
and by pulling the connector.
4. Connect the fuel pump 5P connector.
5.
Turn the ignition switch "ON".
Do not start the
engine.
The fuel pump will run for about 2 seconds, and
fuel pressure will rise.
Repeat 2 or 3 times, and check that there is no
leakage in the fuel supply system.
Install the luggage box (page 3-5).
6-46
LOCKING PAWLS
CONNECTOR
PIPE
CONNECTOR
FUEL PUMP 5P CONNECTOR
FUEL FEED HOSE
RUBBER