Honda SH300 2006 Manual page 183

SYSTEM INSPECTION
Turn the ignition switch "OFF".
Remove the rear fender A (page 3-7).
Remove the two screws and bank angle sensor.
Do not disconnect
the bank angle sen-
sor connector dur-
ing inspection.
Place the bank angle sensor in normal position as
If you perform this
shown, and turn the ignition switch "ON". The bank
test, turn the igni-
angle sensor is normal if the engine stop relay
tion switch "OFF",
clicks, which indicates that circuit is closed.
then turn the igni-
tion switch "ON".
Incline the bank angle sensor approximately 49 ± 4°
to the left or right while the ignition switch is "ON".
The bank angle sensor is normal if the engine stop
relay clicks, which indicates that circuit is opened.
If the bank angle sensor does not operate, refer to
the circuit inspection (page 6-74), if the circuit
inspection is normal, replace the bank angle sensor
with a new one and recheck.
FUEL SYSTEM (PGM-FI)
BANK ANGLE
SENSOR
SCREWS
49 ± 4° BANK ANGLE POSITION
(approximately) 49 ± 4°
Normal
position
(approximately) 49 ± 4°
ENGINE STOP
RELAY
6-73