Install the right handlebar weight and tighten the
new screw.
Set the front master cylinder by aligning the end of
the master cylinder with the punch mark on the han-
dlebar.
Set the holder with the "UP" mark facing up and
tighten the upper bolt first, then tighten the lower
bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the front brake light switch connectors.
Clean the inside surface of the left handlebar grip
and the outside surface of the handlebar.
Apply Honda Bond A or equivalent to the inside sur-
face of the handlebar grip and to the outside surface
of the handlebar.
Wait 3 – 5 minutes and install the grip. Rotate the
Allow the adhesive
grip for even application of the adhesive.
to dry for 1 hour
before using.
FRONT WHEEL/SUSPENSION/STEERING
FRONT MASTER CYLINDER
PUNCH MARK
"UP" MARK
HANDLEBAR GRIP
HANDLEBAR WEIGHT
SCREW
HOLDER
BOLTS
FRONT BRAKE LIGHT
SWITCH CONNECTORS
HANDLEBAR
15-25