Honda SH300 2006 Manual page 338

FRONT WHEEL/SUSPENSION/STEERING
Install the handlebar by aligning the locating pin on
the handlebar and cut-off of the steering stem.
Align the groove of the steering stem with the upper
bolt hole in the handlebar, then install a new upper
handlebar bolt.
Install a new lower handlebar bolt.
Tighten the upper/lower handlebar bolts to the
specified torque.
TORQUE: 128 N·m (13.1 kgf·m, 94 lbf·ft)
Set the following into the cable guides:
Route the cables
and hose properly
– combination meter/handlebar switch wire
(page 1-19).
– rear brake hose
– front brake hose
– throttle cables
Install the upper throttle housing and tighten the
two screws.
15-24
Align
Align
GUIDE
UPPER HOUSING
SCREWS
HANDLEBAR
STEERING
STEM
BOLTS
GUIDE