Dcc Boot Rom - Avaya Media Processing Server 1000 Hardware Installation And Maintenance

Configuration
NIC boot ROM settings need not be set in sequence.
Checking the boot ROM is an interactive process. If you modify any current boot ROM settings, you
are prompted on each individual item to change or accept the current value (by pressing
<RETURN>).

DCC Boot ROM

Perform the following procedure to verify or modify the boot ROM settings for each DCC in the TMS.
Repeat this procedure for all DCC in a TMS, then proceed to
Caution:
Avaya strongly recommends that system configuration changes be made only by qualified
service personnel. If necessary, consult with Avaya technical support or field service
engineering.
Figure 49: TMS Front Panel
1. Connect a serial console to the remote terminal connector of the DCC. See illustration of
Figure 49: TMS Front Panel
2. Cycle the power on the TMS. The ROM banner and the current settings display on the serial
console. Press any key within 5 seconds to suspend the system from booting.
DCC-3000 Rom $Revision: 1.8 $, Checksum = 0x192740c9
dcc3k_rom.elf,
Copyright (C) 2013, Avaya Inc. All rights reserved
--------------------------------------------------------------------------
START-UP MODE:
Run the ROM Bootloader
HOST DEBUGGER CONNECTION (if activated):
Network connection
NETWORK INTERFACE PARAMETERS:
TMS is present
Use Message Exchange to download image
LAN IP address will be obtained from bootp.
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
Processor: MPC8260 (Mask 0x24), PPC_clk = 198MHz, CPM_clk = 165MHz
SDRAM : 64MB, cycle time 8.0ns @ Cas Latency=3
This board's Ethernet hardware address is 00:80:01:D0:08:B1
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
140
on page 140 and
Release ROM-5.0 [05/06/05 05:31:50 PM]
Comments? infodev@avaya.com
TMS Boot ROM
Debug Terminal Connection
on page 142.
on page 158.
October 2014