Dcc Boot Rom Configuration; Tms Boot Rom Configuration - Avaya Media Processing Server 1000 Hardware Installation And Maintenance

Configuration

DCC Boot Rom Configuration

If your boot message is not similar to the following sample, the DCC network mode must be
changed, see DCC Boot ROM
DCC-3000 Rom $Revision: 1.7 $, Checksum = 0x19498300
dcc3k_rom.elf, Release Developmental [12/19/01 11:41:16 AM]
Copyright (C) 2001, Avaya Inc.
--------------------------------------------------------------------------
START-UP MODE:
Run the ROM Bootloader
HOST DEBUGGER CONNECTION (if activated): Network connection
NETWORK INTERFACE PARAMETERS: TMS is present Use Message Exchange to download image
LAN IP address will be obtained from etc/bootptab file
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
Processor: MPC8260 (Mask0x24), PPC_clk = 198MHz, CPM_clk = 165MHz
SDRAM: 64MB, cycle time 10.0ns @ Cas Latency=3
This board's Ethernet hardware address is 00:80:01:D0:00:17
MXD BOOT LOADER PARAMETERS : The download file will come from the TMS STARTUP DELAY:
After board is reset, start-up code will wait 3 seconds
--------------------------------------------------------------------------
Verify and modify the boot ROM for all TMS if necessary, See
this order for each TMS in the system.

TMS Boot ROM Configuration

Note:
Verify that the TMS net address is obtained through bootp. The NETWORK INTERFACE
PARAMETER field in bootp sets the net address. This information is displayed by the system
console when the TMS is powered up or rebooted. compare your output to the following sample.
TMS-2000 Rom Version V3.0, Checksum = 0x0434b441
TMS_rom.elf, Release Developmental [02/14/00 02:00:10 PM]
Copyright (C) 2000, Avaya Incorporated
----------------------------------------------------------
STARTUP MODE:
Run Application
NETWORK INTERFACE PARAMETERS:
LAN IP address will be obtained from etc/bootptab file
LAN interface's subnet mask is 0xffff0000
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
This board's Ethernet hardware address is 00:80:01:80:01:9C
This board's clock frequency is 80 MHz, bus ratio is 1:2
This board has 32 Megabytes of DRAM
SOFTWARE WATCH DOG TIMER STATUS:
The watch dog timer is ENABLED and will timeout / RESET in 120 seconds.
TFTP BOOT LOADER PARAMETERS :
The IP and download file to start will come from the /etc/bootptab file
STARTUP DELAY:
Will wait 5 seconds before start up to allow parameter modifications
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
74
on page 140.
//matches the program memory installed
Comments? infodev@avaya.com
TMS Boot ROM on page 142. Follow
October 2014