Avaya Media Processing Server 1000 Hardware Installation And Maintenance page 123

groupname ipmp_test
ether 0:3:ba:45:7b:39
bge0:1: flags=19040803<UP,BROADCAST,MULTICAST,DEPRECATED,
IPv4,
NOFAILOVER,FAILED> mtu 1500 index 2
inet 10.7.0.3 netmask ffff0000 broadcast 10.7.255.255
bge1: flags=29040843<UP,BROADCAST,RUNNING,MULTICAST,
DEPRECATED,IPv4,
NOFAILOVER,STANDBY> mtu 1500 index 3
inet 10.7.0.2 netmask ffff0000 broadcast 10.7.255.255
groupname ipmp_test
ether 0:3:ba:45:7b:3a
bge1:1: flags=21000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4,
STANDBY> mtu 1500
index 3
inet 10.7.0.1 netmask ffff0000 broadcast 10.7.255.255
Notice the bge0 is marked as FAILED and the IP address 10.7.0.1 is moved from bge0
to bge1:1. Therefore, clients can still reach the host at this address.
d. Connect the cable back to bge0.
e. Execute the ifconfig -a command. Compare your results with the following sample.
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,
VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
bge0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 10.7.0.1 netmask ffff0000 broadcast 10.7.255.255
groupname ipmp_test
ether 0:3:ba:45:7b:39
bge0:1:flags=9040843<UP,BROADCAST,RUNNING,
MULTICAST,DEPRECATED,IPv4
,
NOFAILOVER> mtu 1500 index 2
inet 10.7.0.3 netmask ffff0000 broadcast 10.7.255.255
bge1:
flags=69040843<UP,BROADCAST,RUNNING,MULTICAST,
DEPRECATED,IPv4,
NOFAILOVER,STANDBY,INACTIVE> mtu 1500 index 3
inet 10.7.0.2 netmask ffff0000 broadcast 10.7.255.255
groupname ipmp_test
ether 0:3:ba:45:7b:3a
Note:
• The bge0 is recovered.
• It takes approximately 10 seconds to detect and recover from a failure with the default
configuration.
• The configuration of the IP Networking Multipathing daemon is set in the /etc/default/
mpathd file.
October 2014 Avaya Media Processing Server 1000 Hardware Installation and Maintenance
Comments? infodev@avaya.com
Sun Netra
123