Avaya Media Processing Server 1000 Hardware Installation And Maintenance page 143

For each of the following questions, you can press <Return> to select the
value shown in braces, or you can enter a new value.
How should the board boot?
1. pROBE+ standalone mode
2. pROBE+ waiting for host debugger via serial connection
3. pROBE+ waiting for host debugger via a network connection
4. Run the Application
Which one do you want? [4]
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface?
BOOTP, RARP or FIXEDIP can obtain this Board's IP.
The default method is BOOTP
Enter Y to change the default
Enter 0 for RARP, 1 for BOOTP, 2 for FIXED [1] 1
New configuration is:
Use a subnet mask for the LAN interface?
Should there be a default gateway for packet routing?
HARDWARE PARAMETERS:
Baud rate for serial channels [9600]
Do you want to change the board's clock rate? [N]
Do you want to change the SWT status? [N]
Do you want to change the board's Ethernet address? [N]
ROM BOOTLOADER PARAMETERS:
STARTUP DELAY:
How long (in seconds) to delay before starting up? [5]
To change a value, type the new value after the prompt. Continue until all the values
are confirmed or changed.
When all prompts are finished, the original verify screen is displayed again with new
values. To make additional changes, select the (M)odify option again. To save the
changes and boot, select (C)ontinue.
4. The TMS boots, and a printout such as the following is displayed.
-----------------------------------------------------------
(M)odify any of this or (C)ontinue? [C]
Writing the modified parameters to the removable EEprom
Starting the TFTP download...
...........................................................
...........................................................
...................................
TFTP download completed...
Transferring control to the downloaded code.
TMS_860.elf,
Copyright (C) 2000, Avaya Incorporated
Chassis: 04Backplane Slot Number: 04
Available Processor Memory:
Connecting to Host 192.168.212.2 (port#5500)......ESTABLISHED
Detecting Cards:
Card Revision
---------------------
5036484011_
5036484011_
503643701E_.503643601B_
Loading FPGAs:
Loading TMS-2500 in slot 0, card 0 with TMS484a.sm
...........................................................
October 2014
BOOTP
Release 1.0.0.67 [06/08/00 12:27:13 PM]
26MB
SlotCardType
-------------------------
0 0 TMS-2500
0 1 MDM/TMS-2500
4 0 DCC-2000-T1
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
Comments? infodev@avaya.com
[Y]
[N] y
[N]
TMS Boot ROM
[N]
143