Replacing An Ethernet Switch - Avaya Media Processing Server 1000 Hardware Installation And Maintenance

Maintenance
Date of last repair
In service date - not set
Module Test Tech ID
Logistics Test Tech ID
Checksum
History bins ----------------------
Number of power-ups is
Number of ROM startups is
Number of application startups is
Number of powered on hours
Press RETURN to continue [ESC to abort]
NIC Diagnostic Tests Version 1.0
EEPROM READ/WRITE Main Menu
1) Identify
2) Initialize Initialize a device(EEPROM) on a board
3) Exit
Enter Your Selection
NIC Diagnostic Tests Version 1.0
EEPROM READ/WRITE Main Menu
1) Module Tests
2) Logistics Tests
3) System Tests
4) FLASH script
6) Exit
Enter Your Selection

Replacing an Ethernet Switch

Tools required:
1. Phillips screwdriver.
Procedure:
1. Disconnect all cables from front of unit.
2. Disconnect power cord from rear of unit.
3. Remove the four retaining screws and remove Switch.
4. Slide unit out and replace with new unit.
5. Replace retaining screws and reconnect all cables.
Figure 64: Ethernet Switch Front View
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
230
08/09/2004
= 6
= 6
= FA1C9967 - GOOD NEW
Identify devices
Return to Main menu
- next? [2]3
Return to Main menu
- next? [1]6
Comments? infodev@avaya.com
Factory In service
-1 -1
-1 -1
-1 -1
4 -1
October 2014