Avaya Media Processing Server 1000 Hardware Installation And Maintenance page 90

Configuration
DCC-3000 Rom $Revision: 1.8 $, Checksum = 0x192740c9
dcc3k_rom.elf, Release ROM-5.0 [05/06/05 05:31:50 PM]
Copyright (C) 2013, Avaya Inc. All rights reserved
--------------------------------------------------------------------------
START-UP MODE:
Run the ROM Bootloader
HOST DEBUGGER CONNECTION (if activated):
Network connection
NETWORK INTERFACE PARAMETERS:
TMS is present
Use Message Exchange to download image
LAN IP address will be obtained from bootp.
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
Processor: MPC8260 (Mask 0x24), PPC_clk = 198MHz, CPM_clk = 165MHz
SDRAM : 64MB, cycle time 8.0ns @ Cas Latency=3
This board's Ethernet hardware address is 00:80:01:D0:08:B1
SOFTWARE WATCH DOG TIMER STATUS:
The watch dog timer is DISABLED and will NOT timeout.
MXD BOOT LOADER PARAMETERS :
The download file will come from the TMS
STARTUP DELAY:
After board is reset, start-up code will wait 5 seconds
--------------------------------------------------------------------------
To change any of this, press Enter, Return, or space key within 5 seconds
Check your settings with the previous example and if not correct, modify the DCC boot ROM
settings as shown in the following sample.
To change any of this, press any key within 5 seconds
(M)odify any of this or (C)ontinue? [M] m
For each of the following questions, you can press <Return> to select the value shown
in braces, or you can enter a new value.
How should the board boot?
1. pROBE+ standalone
2. pROBE+ waiting for host debugger via serial connection
3. pROBE+ waiting for host debugger via a network
4. Run the Application
Which one do you want? [4] 4
NETWORK INTERFACE PARAMETERS:
Enter 0 if TMS absent
Enter 1 if TMS present and you'd like to TFTP the image
Enter 2 if TMS is present and you'd like to use the MXD to get the image
: [2] 2
Do you want a LAN interface?
BOOTP, RARP or FIXEDIP can obtain this Board's IP.
The default method is TFTP
Enter Y to change the default
Enter 0 for RARP, 1 for BOOTP, 2 for FIXED [1] 1
New configuration is:
Use a subnet mask for the LAN interface?
Should there be a default gateway for packet routing?
HARDWARE PARAMETERS:
Baud rate for serial channels [9600]
Do you want to change the board's clock rate? [N] n
Do you want to change the SWT status? [N] n
Do you want to change the board's Ethernet address? [N] n
ROM BOOTLOADER PARAMETERS:
STARTUP DELAY:
How long (in seconds) to delay before starting up? [5]
--------------------------------------------------------------
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
90
mode
[Y] y
[N] y
BOOTP
[N] n
Comments? infodev@avaya.com
connection
[N] n
October 2014