Configuration Of Bootp Daemon - Avaya Media Processing Server 1000 Hardware Installation And Maintenance

Figure 48: MPShome Directory Structure

Configuration of bootp Daemon

The file /etc/bootptab is used by the bootp daemon (bootpd) to reply to bootp requests made by the
DCC and TPM cards in a system containing spans. The DCC must always be set for bootp because
it is used in conjunction with a TPM. (see
configuration of the bootptab entries are automated in the future, but for now the entries are
manually inserted as follows:
TPM1100AMR-tms3-155:
tftpboot:bf=ramTPM1100.cmp;tp1100-AMR-7-1.ini
:ht=ethernet:ha=00908f076e91:ip=10.7.156.12
dcc34:sm=255.255.0.0:gw=10.7.203.72:td=/
tftpboot:bf=:ht=ethernet:ha=008001D01015:ip=10.7.156.14
TPM Entries
Configure the TPM entries with the following specifications.
Entry Specification
sm specifies the subnetmask
td (target directory) specifies the directory on the boot server to obtain images and initialization
files.
bf This bootptab entry specifies the TPM image name (ramTPM200.cmp for TPM 200 card,
ramTPM800.cmp for TPM800 card and ramTPM1100.cmp for TPM1000 card) and
initialization file (tp200.ini or tp800.ini or tp1100.ini).
ht The hardware address type (ht) is set to Ethernet.
ha The TPM hardware address (ha) is obtained by taking the TPM serial number and converting
it to hex. This specifies the last four digits of the hardware address. The address is specified
as 00908f00XXXX where XXXX is the TPM serial number in hex.
October 2014
DCC Boot Rom Configuration
:sm=255.255.0.0:gw=10.7.203.72.:td=/
Avaya Media Processing Server 1000 Hardware Installation and Maintenance
Comments? infodev@avaya.com
Configuration of bootp Daemon
on page 74). The
87