70–30
WINDSHIELD/WINDOWGLASS/MIRROR
11.
INSTALL BACK WINDOW MOULDING OUTSIDE UPPER
(a)
Using a brush or sponge, coat the edge of the glass and the contact surface with Primer G.
NOTICE:
Y
Allow the primer coating to dry for 3 minutes or more.
Y
Do not coat the adhesive with Primer G.
Y
Do not keep any of the opened Primer G for later use.
(b)
Install the moulding.
12.
INSTALL BACK WINDOW GLASS ADHESIVE DAM
(a)
Coat the installation part of the back window glass adhesive dam with Primer G.
NOTICE:
Y
Allow the primer coating to dry for 3 minutes or more.
Y
Do not apply too much primer.
(b)
Install a new dam, applying double–sided tape all the way around the glass except where the dam is
installed, as shown in the illustration
Backside
A
A
Standard dimension (a) : 14.0 mm (0.551 in.)
Adhesive
Adhesive
Body
AVENSIS REPAIR MANUAL (RM1018E)
–
BACK WINDOW GLASS (SEDAN MODELS)
13.
INSTALL BACK WINDOW GLASS
(a)
Clean and shape the contact surface of the vehicle body.
(1)
Using a knife, cut away any rough adhesive on the
contact surface of the vehicle body to ensure the
appropriate surface shape.
HINT:
Leave as much adhesive on the vehicle body as possible.
(2)
Clean the contact surface of the vehicle body with
a piece of shop rag saturated with cleaner.
BO4420
HINT:
Even if all the adhesive has been removed, clean the vehicle
body.
http://vnx.su
A – A
a
B67816