Power System Data 1; Description - Siemens 7SC80 Manual

Functions
2.1 General
No. Information
321 Warn Mem. Para.
322 Warn Mem. Oper.
323 Warn Mem. New
335 >GOOSE-Stop
373.3001 HotLineTag int.
373.3002 HotLineTag ext.
444.3003 Bat. Test int.
502 Relay Drop Out
510 Relay CLOSE
545 PU Time
546 TRIP Time
2152 BATTERY INVALID
2155 BAT.CHARGE GOOD
2156 BAT.CHARGE LOW
2157 BATTERY EMPTY
2172 GPS ModuleError
2184 CT LPS mismatch
2186 Error IO board
2240 Multi. routing
2534 HotLineTag act.
2535 >HotLineTag ext
2537 >Start Bat.Test
2538 BatTest aborted
2539 Execut. BatTest
2540 BatTest failed
2541 BatRecov.failed
2596 Test load act.
6009 GPS time ok
6010 GPS antenna ok
6095 >Block Bat Test
6096 Fill Lev1 reach
6097 Fill Lev2 reach
17566 Dist.CFC Src
2.1.3

Power System Data 1

2.1.3.1

Description

The device requires certain data regarding the network and substation so that it can adapt its functions to this
data depending on the application. This may be, for instance, nominal data of the substation and measuring
transformers, polarity and connection of the measured quantities, breaker properties (where applicable), etc.
There are also certain parameters that are common to all functions, i.e. not associated with a specific protec-
tion, control or monitoring function. The following section discusses this data.
48
Type of Comments
Informa-
tion
OUT Warn: Limit of Memory Parameter exceeded
OUT Warn: Limit of Memory Operation exceeded
OUT Warn: Limit of Memory New exceeded
SP >GOOSE-Stop
IntSP Hot Line Tag internal trigger
IntSP Hot Line Tag external trigger
IntSP Battery Test internal trigger
SP Relay Drop Out
SP General CLOSE of relay
VI Time from Pickup to drop out
VI Time from Pickup to TRIP
OUT Invalid or no ext. battery connected
OUT Charge of battery is good
OUT Charge of battery is low
OUT Charge of battery is insufficient
OUT GPS Module Error
OUT CT LoPo/LPS setting mismatch
OUT Error occurred on IO board
OUT Several indications routed
OUT Hot Line Tag is active, no operation
SP >Hot Line Tag external trigger
SP >Start of battery test
OUT Battery test aborted
OUT Executing Battery test
OUT Battery test failed
OUT Battery recovery failed
OUT Battery test load active
OUT Device is GPS time synchronized
OUT GPS antenna is attached correctly
SP >Block battery test
OUT Thresh. reached event log fill level 1
OUT Thresh. reached event log fill level 2
VI Disturbance CFC Source
SIPROTEC Compact, 7SC80, Manual
E50417-G1140-C486-A8, Edition 07.2017