Configure The Ospfv3 Nssa Area - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
In the Area ID field, enter the OSPF area ID.
6.
An area ID is a 32-bit integer in dotted-decimal format that uniquely identifies the area to
which a router interface connects.
In the Import Summary LSAs list, select the Enable or Disable option.
7.
If you select Enable, summary LSAs are imported into areas. The default is Enable.
In the Default Cost field, enter the metric value to be applied for the default route advertised
8.
into the stub area.
The valid values range from 1 to 16,777,215. This value is applicable only to stub areas.
Click the Add button.
9.
The area is configured as a stub area.
Click the Apply button.
10.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Table 140. Advanced OSPFv3 Stub Area Configuration
Field
SPF Runs
Area Border Router Count
Area LSA Count
Area LSA Checksum
Type of Service

Configure the OSPFv3 NSSA Area


To configure the OSPFv3 NSSA area:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Description
The number of times that the intra-area route table was calculated using
this area's link state database. This is done using Dijkstra's algorithm.
The total number of area border routers reachable within this area. This
is initially zero, and is calculated in each SPF Pass.
The total number of link state advertisements in this area's link state
database, excluding AS External LSAs.
The 32-bit unsigned sum of the link state advertisements' LSA
checksums contained in this area's link state database. This sum
excludes external (LSA type 5) link state advertisements. The sum can
be used to determine if there was a change in a router's link state
database, and to compare the link state database of two routers.
This field is the normal ToS associated with the stub metric.
OSPF and OSPFv3
385