NETGEAR M4300 User Manual page 59

M4300 Series and M4300-96X Fully Managed Switches User Manual
Select the radio button to Enable or Disable Address Autoconfigure Mode. If you select
8.
Enable, the IPv6 network parameters (IPv6 prefix and prefix length) are autoconfigured for
the configured management VLAN interface. The default value for VLAN 1 is Auto Config.
The Address Autoconfigure mode option is available only if unicast
Note:
routing is globally disabled.
Select the Address DHCP Mode Enable or Disable radio button.
9.
In the IPv6 VLAN Interface Configuration section of the page, select the IPv6 Prefix/Prefix
10.
Length option, then specify the IPv6 address to add or remove from the management VLAN
interface. When Address Autoconfigure Mode is selected, the appropriate IPv6 prefix and
prefix length is shown in this field.
Select the EU164 option to True (enabled) the Extended Universal Identifier (EUI) flag for an
11.
IPv6 address. The value is False if not specified.
Click the Add button.
12.
The IPv6 address is added to the management VLAN.
Click the Apply button.
13.
Your settings are saved.
In the IPv6 Default Route Configuration section of the page, the nonconfigurable IPv6
Default Route that is displayed is the default route for the IPv6 VLAN interface.
To make changes, do the following:
14.
To add or remove the IPv6 default route, select the Change IPv6 Default Route
•
option, and specify the address value in the IPv6 Default Route Address field.
To reset the IPv6 management interface to the default VLAN 1, select the Set
•
Management Interface to Default option.
If you make any changes, click the Apply button.
15.
Your settings are saved.
By default there is no IPv6 Management Interface.
The current IPv6 Management Interface Status is displayed at the bottom of the page.
Configure System Information
59