Use The Acl Wizard To Complete The Destination Mac Acl; Configure A Basic Mac Acl - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a
destination MAC mask of 00:00:00:ff:ff:ff.
Specify the VLAN ID to compare against an Ethernet frame.
11.
Valid range of values is 1 to 4093. Either a VLAN range or VLAN can be configured.
From the Direction menu, select Inbound or Outbound.
12.
Traffic rule applies either to inbound traffic only or to outbound traffic only.
From the Unit 1 and LAG switch figures onscreen, select the ports and LAGs to which the
13.
rule must apply.
If a port or LAG is not selected, click the port or LAG to select it. If a port or LAG is
selected, click the port or LAG to clear it again.
Click the Add button.
14.
The rule is added to the ACL based on the destination MAC address.
Click the Apply button.
15.
Your settings are saved.

Use the ACL Wizard to Complete the Destination MAC ACL

For information about the ACL Wizard, see
page 586.
To complete the destination MAC ACL using ACL wizard, you must do the following:
Select the destination MAC ACL as ACL type.
1.
Enter the DMAC VLAN as the ACL Rule.
2.
To select the direction and ports to bind the ACL, in the Directions field, select the packet
3.
filtering direction for an ACL.
The options are Inbound or Outbound.
The Port Selection Table specifies the list of all available valid interfaces for ACL
mapping.
All non-routing physical interfaces and interfaces participating in LAG are listed.

Configure a Basic MAC ACL

A MAC ACL consists of a set of rules which are matched sequentially against a packet. When
a packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken,
and the additional rules are not checked for a match. Rules for the MAC ACL are
specified/created using the MAC ACL Rule Configuration page.
Multiple steps are involved in defining a MAC ACL and applying it to the switch:
Create the ACL Name.
1.
Create rules for the ACL.
2.
Use the ACL Wizard to Create a Simple ACL
Manage Device Security
590
on