Configure An Isdp Interface - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
Select the Admin mode Disable or Enable radio button.
6.
This specifies whether the ISDP Service is enabled or disabled. The default value is
Enable.
In the Timer field, specify the period of time between sending new ISDP packets.
7.
The range is 5 to 254 seconds. The default value is 30 seconds.
In the Hold Time field, specify the hold time for ISDP packets that the switch transmits.
8.
The hold time specifies how long a receiving device must store information sent in the
ISDP packet before discarding it. The range 10 to 255 seconds. The default value is 180
seconds.
Select the Version 2 Advertisements Disable or Enable radio button.
9.
This enables or disables the sending of ISDP version 2 packets from the device. The
default value is Enable.
Click the Apply button.
10.
Your settings are saved.
The following table describes the ISDP Advanced Global Configuration fields.
Table 55. ISDP Advanced Global Configuration
Field
Neighbors table last time changed Displays when the Neighbors table last changed.
Device ID
Device ID Format Capability
Device ID Format

Configure an ISDP Interface


To configure an ISDP interface:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
4.
The System Information page displays.
Select System > ISDP > Advanced > Interface Configuration.
5.
Description
The device ID of this switch.
The device ID format capability.
The device ID format.
Configure System Information
153