NETGEAR M4300 User Manual page 283

M4300 Series and M4300-96X Fully Managed Switches User Manual
You can select multiple ports. You can select all ports by selecting the
Note:
check box in the table header.
From the Keep Alive menu, select Enable to specify that loop protection must be enabled
8.
on the port.
By default, loop protection is disabled for a port.
From the RX Action menu, select the action that the switch takes when a loop is detected
9.
on the port:
Log. Log the message when a loop is detected on the port.
•
Disable. Disable the port when a loop is detected. This is the default setting.
•
Both. Log and disable the port when a loop is detected.
•
Click the Apply button.
10.
Your settings are saved.
To refresh the page with the latest information on the switch, click the Update button.
11.
The following table describes the nonconfigurable information displayed on the page.
Table 101. Loop protection interface configuration information
Field
Loop Detected
Loop Count
Time Since Last Loop
Port Status
Auto Recovery Time Left
Errdisable Reason
Description
Indicates (Yes or No) whether a loop is detected on the port.
The number of packets that were received on the port after the loop was detected.
The time since the loop was detected.
The status of the port (Enabled or Disabled).
The time that is left before the port is reenabled through the autorecovery process.
The time is in the range from 30 to 604800 seconds.
The reason that the port was disabled. In addition to being disabled because of loop
protection, the port can be disabled because of Unidirectional Link Detection
(UDLD), a broadcast storm, a unicast storm, and so on.
Configure Switching Information
283