Configure The Secondary Ip Address - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
Use Bandwidth (kbps) to specify the configured bandwidth on this interface.
17.
This parameter communicates the speed of the interface to higher level protocols. OSPF
uses bandwidth to compute link cost. The valid range is 1 to 10000000.
Use ICMP Destination Unreachables to specify the mode of sending ICMP destination
18.
unreachables on this interface.
If this is Disabled then this interface does not send ICMP destination unreachables. By
default destination unreachables mode is enabled.
Use ICMP Redirects to enable or disable ICMP redirects mode.
19.
The router sends an ICMP redirect on an interface only if redirects are enabled both
globally and on the interface. By default ICMP redirects mode is enabled.
Use IP MTU to specify the maximum size of IP packets sent on an interface.
20.
The valid range is 68 bytes to the link MTU. The default value is 0. A value of 0 indicates
that the IP MTU is unconfigured. When the IP MTU is unconfigured, the router uses the
link MTU as the IP MTU. The IP MTU is the maximum frame size minus the length of the
Layer 2 header.
To delete the IP address from the selected interface, click the Delete button.
21.
Click the Apply button.
22.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Table 108. IP Interface Configuration
Field
VLAN ID
OSPF Admin Mode
Link State
Routing Interface Status

Configure the Secondary IP Address


To configure the secondary IP address:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
Description
The VLAN ID for the interface.
Displays the OSPF admin mode of the interface. The default value is
Disable.
The state of the specified interface is either Active or Inactive. An
interface is considered active if it the link is up and it is in forwarding
state.
Indicates whether the link status is up or down.
Routing
303