Configure Denial Of Service Settings - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
Click the Apply button.
10.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Table 193. Console Port
Field
Character Size (bits)
Flow Control
Stop Bits
Parity

Configure Denial of Service Settings


To configure Denial of Service settings:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
4.
The System Information page displays.
Select Security > Access > Denial of Service Configuration.
5.
Description
The number of bits in a character. This is always 8.
Whether hardware flow control is enabled or disabled. It is always
disabled.
The number of stop bits per character. It is always 1.
The parity method used on the serial port. It is always None.
Manage Device Security
524