Configure Advanced Mvr Settings - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual

Configure Advanced MVR Settings


To configure advanced MVR settings:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
4.
The System Information page displays.
Select Switching > MVR > Advanced > MVR Configuration.
5.
Select the MVR Running Enable or Disable radio button.
6.
The factory default is Disable.
Use the MVR Multicast VLAN to specify the VLAN on which MVR multicast data is
7.
received.
All source ports belong to this VLAN. The value can be set in a range of 1 to 4094. The
default value is 1.
Use the MVR Global query response time to set the maximum time to wait for the IGMP
8.
reports membership on a receiver port. This time applies only to receiver-port leave
processing. When an IGMP query is sent from a receiver port, the switch waits for the
default or configured MVR query time for an IGMP group membership report before
removing the port from the multicast group membership. The value is equal to the tenths of
second. The range is from 1 to 100 tenths. The factory default is 5 tenths or one-half.
Select a MVR Mode radio button to specify the MVR mode of operation.
9.
The factory default is compatible.
Click the Apply button.
10.
Your settings are saved.
Configure Switching Information
254