Configure Cos Interface Settings For An Interface - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual

Configure CoS Interface Settings for an Interface

You can apply an interface shaping rate to all interfaces or to a specific interface.

To configure CoS settings for an interface:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
4.
The System Information page displays.
Select QoS > CoS> Advanced > CoS Interface Configuration.
5.
Select one of the following options to specify which interfaces are displayed on the page:
6.
Select LAG to show the list of all LAG interfaces.
•
Select All to show the list of all physical as well as LAG interfaces.
•
Use one of the following methods to select an interface:
7.
Use the Go To Interface field to enter the interface in unit/slot/port format and click
•
the Go button.
The entry corresponding the specified interface is selected.
Select an interface from the Interface list of all CoS configurable interfaces.
•
Use Interface Trust Mode to specify whether or not to trust a particular packet marking at
8.
ingress.
Interface Trust Mode can be one of the following:
Untrusted
•
Configure Quality of Service
462