NETGEAR M4300 User Manual page 308

M4300 Series and M4300-96X Fully Managed Switches User Manual
Use one of the following methods to select an interface:
6.
In the Go To Interface field, enter the interface in the unit/slot/port format and click on
•
the Go button.
Next to the Interface column, select the check box for the interface that you want to
•
configure.
All physical interfaces are valid.
Select Enable or Disable in the IPv6 Mode list.
7.
When IPv6 mode is enabled, the interface is capable of IPv6 operation without a global
address. In this case, an EUI-64 based link-local address is used. The default value is
Disable.
In the DHCPv6 Client Mode list, select to Enable or Disable DHCPv6 client mode on an
8.
interface.
At any point in time, only one interface can act as a client. The default value is Disable.
In the Stateless Address AutoConfig Mode list, select to Enable or Disable Stateless
9.
Address AutoConfig mode on an interface.
The default value is Disable.
In the Routing Mode list, select to Enable or Disable the routing mode of an interface.
10.
The default is Disable.
In the Admin Mode list, select to Enable or Disable IPv6 mode.
11.
The default is Disable. When IPv6 mode is enabled, the interface is capable of IPv6
operation without a global address. In this case, an EUI-64 based link-local address is
used.
In the MTU field, specify the maximum transmit unit on an interface.
12.
If the value is 0, then this interface is not enabled for routing. It is not valid to set this value
to 0 if routing is enabled. The MTU range 1280 to 1500. The default is 1500.
In the Duplicate Address Detection Transmits field, specify the number of duplicate
13.
address detection (DAD) transmits on an interface.
DAD transmits values must be in the range 0 to 600. The default is 1.
Routing
308