Configure Poe Power Settings - NETGEAR M4300 User Manual

M4300 Series and M4300-96X Fully Managed Switches User Manual
Table 43. Nonconfigurable fields on the Advanced PoE Configuration page (continued)
Field
Class
Output Voltage
Output Current
Output Power
Status
Fault Status

Configure PoE Power Settings


To configure PoE power settings:
Launch a web browser.
1.
In the address field of your web browser, enter the IP address of the switch.
2.
The login window opens.
Enter the user name and password.
3.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
4.
The System Information page displays.
Description
The Class defines the range of power a PD is drawing from the system.
Class definitions:
0 – 0.44-12.95 (watts)
1 – 0.44-3.83 (watts)
2 – 0.44-6.48 (watts)
3 – 0.44-12.95 (watts)
4 – 0.44-25.5 (watts)
Current voltage being delivered to device in volts.
Current being delivered to device in mA.
Current power being delivered to device in Watts.
The status is the operational status of the port PD detection.
Disabled. No power being delivered.
•
DeliveringPower. Power is being drawn by device.
•
Fault. Indicates a problem with the port.
•
Test. The port is in test mode.
•
otherFault. The port is idle due to error condition.
•
Searching. The port is not in one of the above states.
•
Describes the error description when the PSE port is in fault status.
No Error. The PSE port is not in any error state.
•
MPS Absent. The PSE port has detected an absence of main
•
power supply.
Short. The PSE port has detected a short circuit condition.
•
Overload.The PD connected to the PSE port tried to provide more
•
power than it is permissible by the hardware.
Power Denied. The PSE port was denied power because of
•
shortage of power or due to administrative action.
Configure System Information
123