NETGEAR M4300 User Manual page 107

M4300 Series and M4300-96X Fully Managed Switches User Manual
Select the Admin mode Disable or Enable radio button.
6.
This enables or disables UDP Relay on the switch. The default value is Disable.
Use Server Address to specify the UDP Relay Server Address in x.x.x.x format.
7.
Use UDP Port to specify the UDP Destination Port.
8.
These ports are supported:
DefaultSet. Relay UDP port 0 packets. This is specified if no UDP port is selected
•
when creating the Relay server.
dhcp. Relay DHCP (UDP port 67) packets.
•
domain. Relay DNS (UDP port 53) packets.
•
isakmp. Relay ISAKMP (UDP port 500) packets.
•
mobile-ip. Relay Mobile IP (UDP port 434) packets
•
nameserver. Relay IEN-116 Name Service (UDP port 42) packets
•
netbios-dgm. Relay NetBIOS Datagram Server (UDP port 138) packets
•
netbios-ns. Relay NetBIOS Name Server (UDP port 137) packets
•
ntp. Relay network time protocol (UDP port 123) packets.
•
pim-auto-rp. Relay PIM auto RP (UDP port 496) packets.
•
rip. Relay Routing Image Protocol (RIP) (UDP port 520) packets
•
tacacs. Relay TACACS (UDP port 49) packet
•
tftp. Relay TFTP (UDP port 69) packets
•
time. Relay time service (UDP port 37) packets
•
Other. If this option is selected, the UDP Port Other Value is enabled. This option
•
permits you to enter your own UDP port in UDP Port Other Value.
Use UDP Port Other Value to specify a UDP Destination Port that lies between 0 and
9.
65535.
Click the Add button.
10.
An entry with the specified configuration is created in the UDP Relay Table.
Click the Apply button.
11.
Configure System Information
107