NETGEAR M4300 User Manual page 583

M4300 Series and M4300-96X Fully Managed Switches User Manual
Select Security > Control > Captive Portal > CP User Configuration.
5.
Enter the local User ID to identify the name of the user.
6.
In the User Name field, enter the name of the user.
7.
The name can contain 1 to 31 alphanumeric characters. Once created, user names
cannot be changed or modified.
In the Edit Password list, select Enable only when you are changing the password.
8.
The default value is Disable.
In the Password field, enter a password for the user.
9.
The password length can be from 8 to 64 characters.
In the Confirm Password field, enter the password for the user again.
10.
Use the Group field to assign the user to a least one user group.
11.
To assign a user to more than one group, press the Ctrl key and click each group. New
users are assigned to the 1-Default user group by default.
In the Session Timeout field, enter the number of seconds a user is permitted to remain
12.
connected to the network.
Once the Session Timeout value is reached, the user is logged out automatically.
In the Idle Timeout field, enter the number of seconds to wait before terminating a session.
13.
A user is logged out once the session idle time-out is reached. If the attribute is 0 or not
present, then use the value configured for the captive portal.
In the Max Bandwidth Down field, enter the maximum rate, in bits per second, at which a
14.
client can receive data from the network.
A value of 0 indicates use global configuration. The range is 0 to 536870911 bps.
In the Max Bandwidth Up field, enter the maximum rate, in bits per second, at which a
15.
client can send data into the network.
A value of 0 indicates use the global limit. The range is 0 to 536870911 bps.
In the Max Input field, enter the number of octets the user is allowed to receive.
16.
After this limit is reached, the user is disconnected. 0 means use the global limit. The
range is 0 to 4294967295.
Manage Device Security
583