NETGEAR M4300 User Manual page 64

M4300 Series and M4300-96X Fully Managed Switches User Manual
Click the Apply button.
12.
Your settings are saved.
In the IPv6 Default Route Configuration section of the page, the nonconfigurable IPv6
Default Route that is displayed is the default route for the IPv6 management interface.
To make changes, do the following:
13.
To add or remove the IPv6 default route, select the Change IPv6 Default Route
•
option, and specify the address value in the IPv6 Default Route Address field.
In the Reset IPv6 Management Interface section of the page, use the Set
•
Management Interface to Default option to delete the port-based IPv6 management
interface configuration and set the IPv6 management interface back to the default
VLAN 1.
If you make any changes, click the Apply button.
14.
Your settings are saved.
The current IPv6 Management Interface Status is displayed at the bottom of the page. The
table below describes the nonconfigurable fields.
Table 18. Current IPv6 Management Interface Status
Field
Management Interface
Link State
IPv6 Routing Interface
Status/Operational Mode
MAC Address
IP Address Configuration Method
IP Address
Subnet Mask
Gateway
Description
Displays the current IPv6 management interface
Indicates whether the link status is up or down.
Indicates whether the link status is up or down for the management
interface.
The MAC address assigned to the management interface.
Indicates whether the IP address configuration method is DHCP or
manual.
The IP address of the management interface.
The IP subnet mask for the management interface.
The specified default gateway for the management interface.
Configure System Information
64