NETGEAR M4300 User Manual page 224

M4300 Series and M4300-96X Fully Managed Switches User Manual
If no MST instances were configured on the switch, the page displays
Note:
a No MSTs Available message and does not display the fields shown
in the field description table that follows.
Use MST ID to select one MST instance from existing MST instances.
6.
Use Interface to select one of the physical or port channel interfaces associated with VLANs
7.
associated with the selected MST instance.
Use Port Priority to specify the priority for a particular port within the selected MST
8.
instance.
The port priority is set in multiples of 16. For example if the priority is attempted to be set
to any value between 0 and 15, it is set to 0. If it is tried to be set to any value between 16
and (2*16-1) it is set to 16 and so on.
Use Port Path Cost to set the Path Cost to a new value for the specified port in the selected
9.
MST instance.
It takes a value in the range of 1 to 200000000.
Click the Apply button.
10.
Your settings are saved.
The following table describes the read-only MST port configuration information displayed on
the Spanning Tree CST Configuration page.
Table 79. MST Port Status
Field
Auto Calculated Port Path Cost
Port ID
Description
Displays whether the path cost is automatically calculated (Enable) or
not (Disable). Path cost is calculated based on the link speed of the
port if the configured value for Port Path Cost is zero.
The port identifier for the specified port within the selected MST
instance. It is made up from the port priority and the interface number of
the port.
Configure Switching Information
224