Preparations For Installation - Omron NX-ECC201 User Manual

6 Installation
6-1-2

Preparations for Installation

You must install the EtherCAT Coupler Unit and NX Units on a DIN Track.
The following products are recommended.
Name
35-mm DIN PFP-50N
Track
PFP-100N
NS 35/7,5 PERF
NS 35/15 PERF
End Plate PFP-M
CLIPFIX 35
Not all of the combinations of the DIN Tracks and End Plates listed above are possible.
Confirm applicability of the combinations in the following table.
DIN Track model
PFP-50N
PFP-100N
NS 35/7,5 PERF
NS 35/15 PERF
6 - 6
Model Manufacturer
OMRON Corporation
OMRON Corporation
Phoenix Contact
Phoenix Contact
OMRON Corporation
Phoenix Contact
PFP-M
(OMRON)
Possible.
Possible.
Possible.
Not possible.
Remarks
• Length: 50 cm
• Material: Aluminum
• Surface treatment: Insulated
• Length: 100 cm
• Material: Aluminum
• Surface treatment: Insulated
• Length: 75.5, 95.5, 115.5, or 200 cm
• Material: Steel
• Surface treatment: Conductive
• Length: 75.5, 95.5, 115.5, or 200 cm
• Material: Steel
• Surface treatment: Conductive
Two End Plates are required for each
EtherCAT Slave Terminal.
Two End Plates are required for each
EtherCAT Slave Terminal.
CLIPFIX 35
(Phoenix Contact)
Possible.
Possible.
Possible.
Possible.
NX-series EtherCAT Coupler Unit User's Manual (W519)