Omron NX-ECC201 User Manual page 302

13 Troubleshooting
Event name Unit Configuration Information Error
Meaning An error occurred in the Unit configuration information in the EtherCAT Coupler Unit.
Source EtherCAT Master Function Mod-
ule
Error Level
attributes
Effects User program
Sys- Variable
tem-defined
None
variables
Cause and Assumed cause
correction
The power supply to the EtherCAT
Coupler Unit was turned OFF or
Sysmac Studio communications
were disconnected while down-
loading the Unit configuration
information.
Attached None
information
Precautions/ None
Remarks
13 - 24
Source details
Minor fault Recovery
Continues. Operation
Data type
---
Correction
Clear all of memory in the Ether-
CAT Coupler Unit, and then down-
load the Unit configuration
information again.
Event code 35000000 hex
EtherCAT Cou- Detection
pler Unit timing
Cycle power to Log category
the EtherCAT
Coupler Unit or
restart the
Slave Terminal.
The Slave Terminal stops in Pre-Operational state.
I/O refreshing for the NX Units in the EtherCAT Slave
Terminal stops. Messages cannot be sent to the NX
Units in the EtherCAT Slave Terminal.
Name
---
Prevention
Do not turn OFF the power supply
to the EtherCAT Coupler Unit or
disconnect Sysmac Studio com-
munications while downloading
the Unit configuration information.
NX-series EtherCAT Coupler Unit User's Manual (W519)
When power is
turned ON to
the EtherCAT
Coupler Unit or
the Slave Ter-
minal is
restarted
System