Omron NX-ECC201 User Manual page 177

Settings
Slave Terminal
Configuration
*1. Register Slave Terminals that are not installed on the EtherCAT network but are scheduled for addition at a
later date as disabled Slave Terminals. Even for a disabled Terminal, you can set process data allocations
and use the process data through system-defined variables and device variables in the user program.
 Setting Parameter
The setting parameter is given in the following table.
Setting
Diagnosis History/Flags
Setting Up the Slave Terminal as an EtherCAT Slave
1
Double-click EtherCAT under Configurations and Setup in the Multiview Explorer.
Or, right-click EtherCAT under Configurations and Setup and select Edit.
2
Drag an EtherCAT Coupler Unit from the Toolbox to the EtherCAT Configuration Edit Tab Page
and drop it under the master.
The EtherCAT Coupler Unit is added under the master.
NX-series EtherCAT Coupler Unit User's Manual (W519)
Settable
These settings are for the Slave Terminal. Click the Edit Slave Terminal Config-
Yes
uration Button to edit these parameters.
Setting range
0 or 1 This parameter specifies whether notification is provided with
emergency messages.
0: No notification
1: Notification
The default setting is 0.
Drag & Drop
9 Setting Up Slave Terminals
Description
Description
EtherCAT Coupler Unit
9
9 - 7