13 Troubleshooting
The timing of indicator flashing is given below.
50 ms
on
Flickering
off
on
Blinking
off
on
Single flash
off
on
Double flash
off
Troubleshooting the Primary Errors That Are Displayed with the UNIT PWR,
L/A IN, L/A OUT, ERR, and TS Indicators
UNIT
L/A IN
PWR
L/A OUT
[green]
[green]
Lit
FK
Not Lit
Not Lit
Lit
---
13 - 4
200 ms 200 ms
1000 ms
200 ms
200 ms
200 ms 200 ms
RUN
ERR
[green]
[red]
Green
Lit
Not
Lit
Lit
Not Lit
Not
Not Lit
Lit
Not Lit
Lit
Not Lit
200 ms
1000 ms
TS
Cause
Red
Not
---
Lit
Not
No power is sup-
Lit
plied by the Unit
power supply.
Lit
Hardware failure
NX-series EtherCAT Coupler Unit User's Manual (W519)
Corrective action
--- (This is the normal status.)
Check the following items and
make sure that power is correctly
supplied from the Unit power sup-
ply.
Checks Related to the Power Sup-
ply
• Make sure that the power supply
cable is wired properly.
• Make sure that there are no
breaks in the power supply
cable.
• Make sure that the power supply
voltage is within the specified
range.
• Make sure that the power supply
has enough capacity.
• Make sure that the power supply
has not failed.
If cycling the power supply to the
EtherCAT Slave Terminal does not
clear the error, replace the Ether-
CAT Coupler Unit.