Omron NX-ECC201 User Manual page 104

6 Installation
 Wiring Ducts
Whenever possible, route I/O wiring through wiring ducts.
Install mounting bases so that it is easy to wire the I/O Units through ducts. It is handy to have the
ducts at the same height as the EtherCAT Slave Terminal.
Duct
20 mm min.
EtherCAT
DIN Track
Slave
Terminal
20 mm min.
Duct
 Wiring Duct Example
30 mm
40 mm
*1. The height of the DIN Track is not considered in this figure.
6 - 4
*1
71 mm
EtherCAT
Slave
Terminal
30 mm Mounting base
EtherCAT
Slave
Terminal
Duct
NX-series EtherCAT Coupler Unit User's Manual (W519)