Omron NX-ECC201 User Manual page 149

Recommended screwdriver
Model
SZF0
 Connecting Ferrules
Insert the ferrule straight into the terminal hole.
It is not necessary to press a flat-blade screwdriver into the release hole.
After you make a connection, make sure that the ferrule is securely connected to the terminal block.
 Connecting Twisted Wires/Solid Wires
Use the following procedure to connect the twisted wires or solid wires to the terminal block.
1
Press the a flat-blade screwdriver diagonally into the release hole.
Press at an angle of 10° to 15°.
If you press in the screwdriver correctly, you will feel the spring in the release hole.
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
NX-series EtherCAT Coupler Unit User's Manual (W519)
Manufacturer
Phoenix Contact
Ferrule
Release hole
Twisted wire/Solid wire
2
7 Wiring
Flat-blade screwdriver
1
10 to 15°
7 - 17
7