Resetting Errors; Introduction; Details On Resetting Errors - Omron NX-ECC201 User Manual

11-9 Resetting Errors

This section describes how to reset errors that occur in the EtherCAT Slave Terminal.

11-9-1 Introduction

The error reset function is used to change the error status of a target EtherCAT Slave Terminal to a nor-
mal state.

11-9-2 Details on Resetting Errors

Error Reset Methods
Refer to 13-4 Resetting Errors on page 13-40 for the error reset methods.
Methods and Specified Range for Resetting Errors
The following table describes how to reset errors in the EtherCAT Slave Terminal from the Sysmac Stu-
dio, and gives the range of errors that you can reset.
Sysmac Studio connection
Peripheral USB port or built-in Ether-
Net/IP port on NJ-series CPU Unit
Peripheral USB port on EtherCAT Cou-
pler Unit
Additional Information
You can use an NS-Series PT to reset errors for the entire Controller.
NX-series EtherCAT Coupler Unit User's Manual (W519)
11 EtherCAT Coupler Unit Functions
Batch reset
Resets all error in the Controller.
This includes resetting errors in
the EtherCAT Slave Terminal.
Resets all errors in the EtherCAT
Slave Terminal.
Individual reset
Resets errors in the specified
Unit.
11 - 27
11