Terminal Cover; Terminal Cover; Models 2A0004 To 2A0081, 4A0002 To 4A0044, 5A0003 To 5A0032 (Ip20/Nema 1, Ul Type 1 Enclosure) - YASKAWA P1000 Technical Manual
Models:
200 v class: 3/4 to 175 hp nd
400 v class: 3/4 to 1000 hp nd
600 v class: 1 to 250 hp nd
Hide thumbs
Also See for P1000:
- Technical manual (412 pages) ,
- Quick start manual (256 pages) ,
- Safety precautions (74 pages)
Table of Contents
Advertisement
3.5
Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is complete.
u
Models 2A0004 to 2A0081, 4A0002 to 4A0044, 5A0003 to 5A0032 (IP20/NEMA 1, UL Type
1 Enclosure)
n
Removing the Terminal Cover
1.
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 3.13 Removing the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.14 Removing the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
n
Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 94
and
Wiring the Control Circuit Terminal
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3.15 Reattaching the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
Refer to Wiring the Main Circuit Terminal on
on page
98
for details on wiring.
<1>
3.5 Terminal Cover
3
77
- Quick Links:
- Drive Alarms, Faults, and Errors
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
