YASKAWA P1000 Technical Manual page 53

Keypad Kit Model
UUX000526
UUX000527
Installation Types and Required Materials
The digital operator mounts to an enclosure two different ways:
• External/face-mount installs the operator outside the enclosure panel
• Internal/flush-mount installs the operator inside the enclosure panel
Installation
Description
Method
Simplified installation with
External/ the digital operator is
Face-Mount mounted on the outside of
the panel with two screws.
Encloses the digital
operator in the panel. The
Internal/
front of the digital operator
Flush-Mount
is flush with the outside of
the panel.
NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and project
construction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during installation.
Remove the temporary cover before drive start-up, as the cover will reduce ventilation and cause the drive to overheat.
External/Face-Mount
1.
Cut an opening in the enclosure panel for the digital operator as shown in
2.
Position the digital operator so the display faces outwards, and mount it to the enclosure panel as shown in
2.11.
YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
Table 2.2 Installation Environment
Blank label on the front.
Yaskawa brand label on the front.
Table 2.3 Digital Operator Installation Methods and Required Tools
Installation
Support Sets
Installation Support Set A
(for mounting with screws
through holes in the panel)
Installation Support Set B
(for use with threaded studs
that are fixed to the panel)
Digital Operator
Figure 2.11 External/Face-Mount Installation
Figure 2.12 Panel Cut-Out Dimensions (External/Face-Mount Installation)
Description
Model
–
EZZ020642A
EZZ020642B
Figure
M3 x 6
Phillips recessed
pan head machine screw x 2
Enclosure panel
Unit: mm
22
22
14
Unit: mm
2.2 Mechanical Installation
Required Tools
Phillips screwdriver
–
(#1)
Phillips screwdriver
(#1, #2)
Phillips screwdriver (#1)
Wrench (7 mm)
2.12.
Figure
2
53