Terminal Cover; Terminal Cover; Models 5A0003 To 5A0032 (Ip20/Nema 1, Ul Type 1 Enclosure) - YASKAWA Z1000 User Manual

3.5 Terminal Cover

3.5

Terminal Cover

Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is complete.
u

Models 5A0003 to 5A0032 (IP20/NEMA 1, UL Type 1 Enclosure)

n Removing the Terminal Cover
1.
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 3.7 Removing the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.8 Removing the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
n Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 85 and Wiring the Control Circuit Terminal
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3.9 Reattaching the Terminal Cover on an IP20/NEMA 1, UL Type 1 Enclosure Drive
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
76
Refer to Wiring the Main Circuit Terminal on
on page 89 for details on wiring.
<1>
YASKAWA TOEP YAIZ1U 03B YASKAWA AC Drive – Z1000 User Manual