E2: Motor 1 Parameters - YASKAWA P1000 Technical Manual

u

E2: Motor 1 Parameters

No.
(Addr. Name
Hex)
E2-01
Motor Rated Current
(30E)
E2-02
Motor Rated Slip
(30F)
E2-03
Motor No-Load Current
(310)
E2-04
Number of Motor Poles
(311)
E2-05 Motor Line-to-Line
(312) Resistance
E2-06
Motor Leakage Inductance
(313)
E2-10 Motor Iron Loss for Torque
(317) Compensation
E2-11
Motor Rated Power
(318)
<1> Default setting is dependent on parameter o2-04, Drive Model Selection.
<2> The number of decimal places in the parameter value depends on the drive model 1. This value has two decimal places (0.01 A) if the drive is set
for a maximum applicable motor capacity up to and including 11 kW, and one decimal place (0.1 A) if the maximum applicable motor capacity is
higher than 11 kW.
YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
Description
Sets the motor nameplate full load current in amps. Automatically set during
Auto-Tuning.
Sets the motor rated slip. Automatically set during Auto-Tuning.
Sets the no-load current for the motor. Automatically set during Auto-Tuning. Default:
Sets the number of motor poles. Automatically set during Auto-Tuning.
Sets the phase-to-phase motor resistance. Automatically set during
Auto-Tuning.
Sets the voltage drop due to motor leakage inductance as a percentage of motor
rated voltage. Automatically set during Auto-Tuning.
Sets the motor iron loss.
Sets the motor rated power in kilowatts (1 HP = 0.746 kW). Automatically set
during Auto-Tuning.
B.6 E: Motor Parameters
Values Page
<1>
Default:
Min.: 10% of drive
rated current
195
Max.: 200% of
drive rated current
<2>
<1>
Default:
195
Min.: 0.00 Hz
Max.: 20.00 Hz
<1>
Min.: 0 A 196
<2>
Max.: E2-01
Default: 4
Min.: 2 196
Max.: 48
<1>
Default:
196
Min.: 0.000 Ω
Max.: 65.000 Ω
<1>
Default:
196
Min.: 0.0%
Max.: 40.0%
<1>
Default:
196
Min.: 0 W
Max.: 65535 W
<1>
Default:
196
Min.: 0.00 kW
Max.: 650.00 kW
447
B