Terminal Cover; Terminal Cover; Ip20/Nema Type 1 - YASKAWA AC Drive-A1000 Technical Manual

3.5

Terminal Cover

Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is complete.
u

IP20/NEMA Type 1

n Removing the Terminal Cover
1.
Loosen the terminal cover screw.
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
n Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 60 and Wiring the Control Circuit Terminal
Reattach the terminal cover after completing the wiring to the drive and other devices.
YASKAWA ELECTRIC SIEP C710616 31B YASKAWA AC Drive – A1000 Technical Manual
Figure 3.4 Removing the Terminal Cover on an IP20/NEMA Type 1 Drive
Figure 3.5 Removing the Terminal Cover on an IP20/NEMA Type 1 Drive
on page
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
Figure 3.6 Reattaching the Terminal Cover on an IP20/NEMA Type 1 Drive
Refer to Wiring the Main Circuit Terminal on
65 for details on wiring.

3.5 Terminal Cover

3
55