Config Bgp Aggregate_Next_Hop_Check [Enable | Disable]; Config Bgp Fast_External_Fallover [Enable | Disable] - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format

config bgp aggregate_next_hop_check [enable | disable]

Parameters
enable - Specifies that the BGP aggregate next hop check will be enabled.
disable - Specifies that the BGP aggregate next hop check will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This is an example of configuring the BGP aggregate next hop check:
DGS-3620-28PC:admin# config bgp aggregate_next_hop_check enable
Command: config bgp aggregate_next_hop_check enable
Success.
DGS-3620-28PC:admin#
12-55 config bgp fast_external_fallover
Description
This command configures a Border Gateway Protocol (BGP) routing process to immediately reset
its external BGP peer sessions if the link used to reach these peers goes down,
Format

config bgp fast_external_fallover [enable | disable]

Parameters
enable - To enable BGP fast external fallover flag. Default is enabled.
disable - To disable BGP fast external fallover.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This example disables BGP fast external fallver:
221