D-Link xStack DGS-3620 Reference Manual page 46

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the parameters that control the operation of the authenticator associated with a port:
DGS-3620-28PC:admin# config 802.1x auth_parameter ports 1-20 direction both
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
DGS-3620-28PC:admin#
3-12 config 802.1x authorization attributes radius
Description
This command is used to enable or disable the acceptation of an authorized configuration. (To
configure that attributes, regarding VLAN, 802.1p, ACL and Ingress/Egress Bandwidth, please
refer to the Appendix section at the end of this document.)
Format
config 802.1x authorization attributes radius [enable | disable]
Parameters
enable - The authorization attributes such as VLAN, 802.1p default priority, and ACL assigned by
the RADUIS server will be accepted if the global authorization status is enabled. The default
state is enabled.
disable - The authorization attributes assigned by the RADUIS server will not be accepted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the 802.1X state of acceptation of an authorized configuration:
DGS-3620-28PC:admin#config 802.1x authorization attributes radius enable
Command: config 802.1x authorization attributes radius enable
Success.
DGS-3620-28PC:admin#
3-13 config 802.1x init
Description
This command is used to initialize the authentication state machine of some or all.
41