Show Cfm Port - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - (Optional) Specifies the maintenance association name.
<string 22> - Enter the maintenance association name. The maximum length is 22
characters.
ma_index - Specifies the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
Restrictions
None. (EI Mode Only Command)
Example
To display the MEPs that have faults:
DGS-3620-28PC:admin#show cfm fault
Command: show cfm fault
MD Name MA Name
----------- ----------- ----- ---------------------- ------------ ------------
op_domain op1
DGS-3620-28PC:admin#
15-16

show cfm port

Description
This command is used to display MEPs and MIPs created on a port.
Format
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-4094>}
Parameters
<port> - Enter the port number.
level - (Optional) Specifies the maintenance domain level. If not specified, all levels are shown.
<int 0-7> - Enter the value between 0 and 7.
direction - (Optional) Specifies the MEP direction.
inward - Specifies inward facing MEP.
outward - Specifies outward facing MEP.
vlanid - (Optional) Specifies the VLAN identifier. If not specified, all VLANs are displayed.
<vlanid 1-4094> - Enter the VLAN ID between 1 and 4094.
Restrictions
None. (EI Mode Only Command)
Example
To display a CFM port:
MEPID Status
1 Error CCM Received
246
AIS Status LCK Status
Normal Normal