Enable Bgp - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
[add | delete] <list_name 16> | prefix_list [in | out] [add | delete] <list_name 16> |
capability_orf_prefix_list [receive | send | both | none]}(1)
show bgp peer_group {<peer_group_name 16>}
config bgp route_reflector cluster_id <ipaddr>
config bgp client_to_client_reflection [enable | disable]
config bgp confederation identifier <as_number 0-4294967295>
config bgp confederation peers [add | delete] <aspath_list>
clear bgp [all | ipaddr <ipaddr> | as <as_number 1-4294967295> | peer_group
<peer_group_name 16> | external] {soft {[in {prefix_filter} | out]}}
clear bgp dampening {[<ipaddr> | <network_address>]}
create bgp as_path access_list <list_name 16>
config bgp as_path access_list <list_name 16> [add | delete] <regexp_str 80> [deny | permit]
delete bgp as_path access_list [list_name <list_name 16> | all]
show bgp as_path access_list {<list_name 16>}
create bgp community_list [standard | expanded] <list_name 16>
config bgp community_list [standard <list_name 16> [add | delete] {internet | local_as |
no_advertise | no_export | community_set <community_set 80>}(1) [deny | permit] | expanded
<list_name 16> [add | delete] <regexp_str 80> [deny | permit]]
delete bgp community_list [list_name <list_name 16> | all]
show bgp community_list {<list_name 16>}
show bgp route {[regexp <desc 80> | inconsistent_as | cidr_only | filter_list <list_name 16> |
route_map <map_name 16> | community {community_set <community_set 80> | local_as |
no_advertise | no_export | internet} {exact_match} | community_list <list_name 16>
{exact_match} | ipaddress <ipaddr> | network <network_address> {longer_prefixes} |
prefix_list <list_name 16>]}
show bgp neighbors {<ipaddr> {[advertised_routes | received_routes | routes |
received_prefix_filter | statistics]}}
show bgp dampened_routes
show bgp flap_statistics
show bgp {summary}
show bgp reflection
show bgp confederation
config bgp trap [peer_established | peer_idle | all] [enable | disable]
show bgp trap_state
config bgp scan_timer [<sec 5-60> | default]
config bgp aggregate_next_hop_check [enable | disable]
config bgp fast_external_fallover [enable | disable]
config bgp neighbor maximum_prefix [<ipaddr> | peer_group <peer_group_name 16>] <value
1-12000> {<value 1-100>} {warning_only}
clear bgp flap_statistics {[<ipaddr> | <network_address>]}
13-1

enable bgp

Description
This command is used to enable the BGP protocol. By enabling the BGP protocol, all the previous
configurations will be applied to the protocol kernel and start. By default, BGP is disabled.
Format
enable bgp
Parameters
None.
175