D-Link xStack DGS-3620 Reference Manual page 290

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
None. (EI Mode Only Command)
Example
To display route redistributions:
DGS-3620-28PC:admin#show route redistribute dst bgp
Command: show route redistribute dst bgp
Route Redistribution Settings
Source Destination
Protocol Protocol
-------- ------------
Total Entries : 0
DGS-3620-28PC:admin#
18-15 show route redistribute dst ospf
Description
This command is used to display the route redistribution settings on the Switch. It displays the
redistribution with the target protocol OSPF.
Format
show route redistribute dst ospf {src [local | static | rip | bgp]}
Parameters
src - (Optional) Specifies the source protocol.
local - Display the redistribution with the source local.
static - Display the redistribution with the source static.
rip - Display the redistribution with the source RIP.
bgp - Display the redistribution with the source BGP. (EI Mode Only Parameter)
If no parameter is specified, the system will display all route redistributions.
Restrictions
None.
Example
To display route redistributions:
Type Metric
-------- ------
285
RouteMapName
------------